Frigidaire FRA123KT1 Manual de usuario descargar pdf

READ BEFORE INSTALLING UNIT

For Slider Casement Air Conditioners

Installation Instructions

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp

edges that may be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to

move and install the unit. To prevent injury or strain, use proper lifting and carrying techniques when moving unit.

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over

an extended period of time.

Handle air conditioner with care. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp

metal fins of front and rear coils.

Make sure air conditioner does not fall during installation.

NOTE:

These instructions describe installation in a typical wood framed window with a wood SLIDE-BY sash, or

installation in a metal CASEMENT window. Modification may be necessary when installing in windows made

differently than those shown in these instructions.

$KLJKZLQGRZDFFHVVRU\NLWLVDYDLODEOHIRUZLQGRZKHLJKWVXSWRƎPP3DUW($:

WARNING:

Electrical ground is required on this appliance.

(OHFWULFDO6KRFNDQG3HUVRQDO,QMXU\+D]DUG

DO NOT ground to a gas line.

If cold water pipe is interrupted by plastic, non-metallic gaskets, or other insulating materials, DO NOT use for

grounding.

Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded.

DO NOT modify power supply cord plug. If it does not fit outlet, have a proper outlet installed by a qualified

electrician.

DO NOT have a fuse in the neutral or grounding circuit. A fuse in the neutral, or grounding circuit could result in

an electrical shock.

DO NOT use an extension cord with this appliance.

Failure to follow these instructions could result in electrical shock, serious injury, or death.

Meeting Electrical Requirements

OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES. DO NOT, UNDER ANY CIRCUMSTANCES,

5(029(7+(32:(56833/<&25'*5281',1*3521*

NOTE:

If codes permit, and a separate grounding wire is used, it is recommended that a qualified electrician determine

that the grounding path is adequate and not interrupted by plastic, non-metallic gaskets, or other insulating

materials.

$

1 2 3 4 5 6 7 8

Installation Instructions 1

Indice de contenidos

Pagina 1 - Installation Instructions

READ BEFORE INSTALLING UNITFor Slider Casement Air Conditioners1Installation InstructionsTo avoid risk of personal injury, property damage, or product

Pagina 2

2Installation InstructionsReceptacle Wiring:Receptacle wiring should be a minimum of 14 gauge. Use copper wire only. It is your responsibility to prov

Pagina 3

3Installation InstructionsMake sure you have all the necessary parts.Installation kit contents (FIG.3):HardwareSide channel sealSupport bracePlatformA

Pagina 4

4Installation Instructions Choose the proper window location.Choose a window that allows the cooled air to flow freely and directlyinto room(s)

Pagina 5

5Installation Instructions Place platform assembly, with platform tab against inside of windowtrack, and attach it to window jamb (FIG.11). Use

Pagina 6

safety bracketFIG.186Installation Instructions Slide inner window sash firmly against side of the cabinet. Make sure not to peel the seal strips

Pagina 7

7Installation InstructionsNOTE:If you are planning to use a siding-protection board (see Step 29) on the outside of your house, hold the board inplace

Pagina 8

8Installation Instructions Cut side channel seal into 2 equal lengths. Remove the protective backing and apply it to the rear side of thecabinet